HTPC Systems









 Storage Systems




 Set Top PC's



 Gaming Systems
























 HDTV Reception







 General Info




 Shopping Cart


ATF-V300 Precision Tilter


  • Accurate positioning of an over the air (OTA) antenna provides the strongest signal possible, allowing you to tune in the weakest stations.

  • Long, high gain Yagi style antennas have a narrow beamwidth in both the horizontal and vertical planes. These antennas must be positioned correctly for best results. 

  • Remotely-controlled positioning allows you to easily fine tune the optimum angle of the antenna for the strongest possible signal.

  • Vertical position is extremely important in areas where nearby mountains ridges and hills block direct line of sight. 

  • Vertical tilting allows you to pin point the direction of the reflected signal.



  • Utilizes standard satellite dish positioning components for lowest cost.

  • Works with most all Yagi style antennas (Blake, Channel Master, Radio Shack, Televes, Winegard) with either round or square boom supports.

  • Simple and rugged design to provide years of trouble free service.

  • Linear actuator provides precision control of antenna position.

  • Electronic digital display controller with infrared remote control.

  • 99 position memory, not affected by power outage.

  • New mast support is shorter and swept forward to balance the static and dynamic load evenly throughout the entire mast system

  • 40 degrees total angular motion, 25 degrees up, 15 degrees down.

  • Unique compact antenna mounting brackets feature vertically orientated U-bolts to prevent unwanted signal interference.

  • Bronze bearings in main pivot for long lasting smooth operation.

  • Precise TIG welded steel construction.

  • Powder Coated for corrosion protection.


Precision Tilter

Complete antenna tilting system includes:

  • Support mast with pivoting bracket

  • 12" linear actuator

  • Controller with infrared remote control

  • Upper actuator mounting bracket

  • Zinc-plated hardware and U-bolts

This tilter can be used with a single antenna or with a Dual Antenna Boom Assembly for stacking two antennas side by side. Order CC-5C control cable separately.

$325 N/A




Copyright 2001-2018  A-Tech Fabrication Company. All rights reserved.